Skip to content
Technical tip

Mounting a keyed slitting saw

If your arbor drives the saw with a key, seat the keyway against the key before you tighten the nut. Three steps, every time the saw goes on. It reduces the shock on the keyway, where cracks start.

Turn the saw backward against the key, then tighten the nut

Who does this
The person who mounts the saw (operator or setup)
Applies to
Any slitting saw with a keyway, on an arbor with a drive key

Before you start. Machine stopped and locked out. Check both keyway corners: never run a saw that shows a crack. Use a rag or gloves, the teeth are sharp.

ARBORSAWAKEY2TURN SAWBACKWARDby hand, until itstops on the keyCUTTINGROTATIONthe way theteeth cut
Shown for a saw cutting clockwise. If yours cuts counter-clockwise, mirror the picture. The rule is the same: turn the saw backward onto the key.
  1. 1

    Slide the saw on

    Slide the saw on over the key. Leave the nut loose.

  2. 2

    Turn the saw backward

    Turn the saw backward by hand, against the direction the teeth cut, until it stops on the key. It only moves a little.

  3. 3

    Snug, then tighten

    Keep light backward pressure on the saw and snug the nut by hand. Then tighten.

When you tighten. Hold the arbor with its wrench or the spindle lock, never by the saw. If the saw turns with the nut, loosen it and start again.

Why it matters: close-up of the key (A)

A keyway has a little clearance around the drive key. Which side that clearance ends up on decides what happens when the teeth enter the cut.

CORRECT

Keyway seated on the key

KEYNO GAPclearancesmall radius in each cornerSAWARBOR
The key is already touching the keyway. The load comes on smoothly.
WRONG

Gap on the driving side

KEYGAPCRACKSAWARBOR
If the saw slips as the teeth enter the cut, the keyway slams back into the key. The shock concentrates at the small corner radius, where cracks start.

The key turns with the arbor and pushes the saw in the cutting direction (to the right in these close-ups). The clearance is drawn larger than real so you can see it.

If cracks still show up: full-radius (round) keyway

RobbJack can make the same saw with one large radius in place of the two small corner radii.

Standard keyway

Small radius in each cornerSAWBORE
A small radius in each corner. Under shock, stress concentrates there, and in carbide a crack can start.

Full-radius (round) keyway

One full radiusSAWBORE
One full radius in place of the two small ones. The load spreads around a much larger curve.

Pictures show the shape only and are not to scale. RobbJack confirms the fit to your arbor and key before making the saws.

Three quick checks at every saw change

Key

No burrs, dents or mushroomed edges. Replace a damaged key. After any saw failure, check the key, the key slot and the arbor under the saw.

Top of the key

With the nut loose, the saw has a little play on the key. The key touches only the keyway's straight side, never its top or corner radius.

Clamping

Flange and spacer faces clean and flat. Nut at the arbor maker's torque, so the clamp carries most of the load and the key takes less.

The clamp should carry most of the cutting load, so the key takes less. RobbJack's NAB saw arbors grip the saw up to 15× more tightly than a standard arbor. A keyway and key for positive drive are made on request. For the full procedure to clean, ring in and indicate a saw, see the slitting saw setup guide.