PCD Composite Finish Router 0.375-in Dia, 2 Flute, 0.75-in LOC, 2.5-in OAL

These PCD routers are best used of trimming composite materials such as fiberglass or carbon fiber CFRP or abrasive materials. The CPCD series comes with a drill point that helps eliminate break out of the material when first plunging into the material. Can be used to rough and finish parts in a single pas eliminating cycle time and linear inches required to cut parts in abrasive materials.

PREVIEW AND DIAGRAM (PCD-203-CF)

Specifications

Cutting Dia 0.375″
Flute Len 0.75″
Shank Dia 0.375″
Overall Len 2.5″
Corner Radius 0″

Tolerances

Cutting Diameter±.003″
Length of Cut±.030″
Shank Diameter−.0001/−.0002″
Overall Length±.060″

Catalog

Catalog Page 59

Speed & Feeds

Other Tools in this Series

Tool # Cutting Dia Flute Len Shank Dia Overall Len Corner Radius Coatings Pg. #
PCD-203-04-CF0.125″0.375″0.125″1.5″0″Uncoated59
PCD-203-06-CF0.1875″0.5″0.1875″2″0″Uncoated59
PCD-203-08-CF0.25″0.625″0.25″2″0″Uncoated59
PCD-203-16-CF0.5″1″0.5″3″0″Uncoated59
PCD-203-20-CF0.625″1″0.625″3.5″0″Uncoated59
PCD-203-24-CF0.75″1″0.75″4″0″Uncoated59
close

SPEEDS & FEEDS